Are you thinking about remodeling your bathroom or just updating your vanity? It may seem like a daunting task. You may be wondering where to start and how to go about doing it. Below is step by step instructions on how to change the vanity in your bathroom. Unsure how to do the plumbing contact plumbers around me.
Tools
The first thing that you will need to do is gather the proper tools for the job. These are the tools that you will need to do the job properly. It is essential to have all of the following tools for the job as they will make the job process go a lot faster. The tools that you will need are a pencil, carpenter’s level, pipe wrench, screw driver, stud finder, utility knife, bucket, tape measure and paper towels.
Materials
Then I will need to gather the materials that are needed for the job. You will need shims, faucet, tub caulk, plumber’s tape, tile caulk, vanity, and a p-trap. These you will need to get the job done properly. These are very important things to have to do the job. If you do not have them then you will need to run out in the middle of the job to get them. Now for the instructions on how to replace the bathroom vanity.
Step by Step Instructions
Shut off the water to the vanity
Turn off the water and disconnect the water supply lines to the sink. Water may drip from the water supply line or the p-trap so place the bucket under them to collect any water that may drip down.
Remove the Countertop.
Gently loosen the caulk that is between the wall and the vanity using a utility knife. All along the sides go all the way to the floor to loosen the caulk that is there. To keep from damaging the wall carefully remove the countertop.
Remove the Old Vanity
Unattach the vanity from the wall by loosening and removing the screw that hold it in place. You will want to make sure that the screws do not get stripped in the process of removing them from the wall.
Find the Studs and Position the Vanity
You will need to locate the studs in the walls and mark them with the pencil. Make sure that you mark the studs a little bit higher than the new vanity. Next mark the new screw holes of the new vanity with a pencil. Then put the vanity in place and make sure that it is flush with the wall. You may have to use the shims to make it level. You will use the carpenter’s level to make sure that it is level.
Install the New Faucet
Follow the manufacturer’s instructions to install the new faucet to the vanity top. You will then attach the bathroom vanity to the wall. Once it is positioned screw the vanity to the wall.
Secure the Vanity Top
You will do this by running a bead of tub or tile caulk around the top edges of the vanity base. Then place the vanity top on the top of the vanity to secure it.
Reconnect the Plumbing
Reconnect all the plumbing lines and if the p-trap is old replace it. Use plumber’s tape to make sure that the connections are tight. If necessary, contact plumbers around me.
Finish the Job
Apple a thin bead of the caulk around the countertop edges to secure it to the wall and vanity. Use the tip of your finger or a damp rag to smooth the application of the caulk.